Home › DRIVE LINE › PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)

FRONT PROPELLER SHAFT ASSEMBLY (for 4WD) > REMOVAL

for Preparation Click here



1. REMOVE EXHAUST FRONT PIPE ASSEMBLY NO. 2 (for 1GR-FE)
  1. Remove the 2 bolts and 2 nuts, then separate the exhaust front pipe No. 2 from the exhaust front pipe.

  1. Remove the 2 nuts, then separate the exhaust front pipe No. 2 from the exhaust manifold LH.

  1. Separate the insulator, then remove the exhaust front pipe No. 2.



2. REMOVE PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY


F052217
  1. Remove the 2 bolts and propeller shaft heat insulator bracket.



3. REMOVE FRONT PROPELLER SHAFT ASSEMBLY


C098708E02
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts, 4 washers and front propeller shaft.



    C098709E02
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts, 4 washers and front propeller shaft.