Home › DRIVE LINE › PROPELLER SHAFT › REAR PROPELLER SHAFT ASSEMBLY (for Access Cab 4WD and Double Cab 4WD)

REAR PROPELLER SHAFT ASSEMBLY (for Access Cab 4WD and Double Cab 4WD) > INSPECTION

for Preparation Click here



1. INSPECT PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY


D033928
  1. Using a dial indicator, check the propeller shaft runout.

    Maximum runout:
    0.6 mm (0.024 in.)

    If the shaft runout is greater than the maximum, replace the shaft.



2. INSPECT PROPELLER SHAFT


D033929
  1. Using a dial indicator, check the propeller shaft runout.

    Maximum runout:
    0.6 mm (0.024 in.)

    If the shaft runout is greater than the maximum, replace the shaft.