Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for Regular Cab 2WD)

PROPELLER SHAFT ASSEMBLY (for Regular Cab 2WD) > DISASSEMBLY

for Preparation Click here



1. INSPECT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING
  1. Check the spider bearings for wear and damage.

  1. Check the spider bearing axial play by turning the yoke with holding the shaft tightly.

    Maximum bearing axial play:
    0 to 0.05 mm (0 to 0.002 in.)

    If the bearing axial play is greater than the maximum, replace the spider bearing.



2. REMOVE PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING


D033919E01
  1. Place matchmarks on the propeller shaft and yoke.



    D033918
  1. Using a brass bar and a hammer, slightly tap in the spider bearing outer races.

  1. Using needle-nose pliers, remove the 4 snap rings from the grooves.



    F015025E02
  1. Using SST, push the spider bearing out of the propeller shaft.

    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.



    F044192E01
  1. Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.

    NOTICE:
    Do not tap the shaft.

    HINT:
    Remove the spider bearing on the opposite side in the same procedure.



    F015030E02
  1. Install the 2 removed spider bearing outer races onto the spider, and clamp them in a vise.

  1. Using SST, push the bearing out of the yoke.

    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.



    F044193E02
  1. Clamp the outer bearing race in a vise and tap off the yoke with a hammer.

  1. Remove the spider.