Home › BODY ELECTRICAL › HORN › HORN SYSTEM

HORN SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT HORN FUSE


E075976
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between each terminals.

      Standard resistance:
      Below 1 Ω

      If the result is not as specified, replace the fuse.



2. INSPECT HORN RELAY


A094272
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.
      Standard resistance: 
      Tester Connection
      Specified Condition
      3-5
      10 kΩ or higher
      3-5
      Below 1 Ω (When battery voltage applied to terminals 1 and 2)



3. INSPECT HIGH PITCHED HORN ASSEMBLY


B089600
  1. Check the operation.

    1. Apply battery voltage, then check the horn.
      OK: 
      Measurement Condition
      Specified Operation
      Battery positive(+) → Terminal 1
      Battery negative(-) → Horn bracket
      Horn sounds
      If the result is not as specified, replace the horn.



4. INSPECT LOW PITCHED HORN ASSEMBLY


B089601
  1. Check the operation.

    1. Apply battery voltage, then check the horn.
      OK: 
      Measurement Condition
      Specified Operation
      Battery positive(+) → Terminal 1
      Battery negative(-) → Horn bracket
      Horn sounds
      If the result is not as specified, replace the horn.
      If all the check results are as specified above and the wire harness is normal, replace the horn button switch (steering wheel pad) .