Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT NO. 1 SPEAKER (except Regular Cab)

FRONT NO. 1 SPEAKER (except Regular Cab) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY


E075953E02
  1. Install the front No. 1 speaker assembly with the 4 screws.

  1. Connect the connector.



2. INSTALL FRONT DOOR TRIM PANEL ASSEMBLY LH


B088116E01
  1. Engage the 10 clips and install the front door trim panel assembly LH.



    B088115
  1. Install the 3 screws.



    B088114E01
  1. Engage the 8 claws and install the door assist grip cover LH.



    B088406
  1. Close the cover.



3. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH


B088092E01
  1. Engage the 3 clips and install the front door lower frame bracket garnish LH.

    NOTICE:
    Confirm that no clips remain on the door panel before the garnish is installed. Transfer any remaining clips to the garnish side before installing it. Installing the garnish with any clips remaining on the door panel side could cause the clips to drop inside the door panel.



4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (w/ Power Door Lock)


B088412E01
  1. Connect the connector.

  1. Engage the 3 claws and clip, and install the power window regulator master switch assembly.



5. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Door Lock)


B088407E01
  1. Install the window regulator handle plate.



    B088408E01
  1. Install the front door window regulator handle assembly with the snap ring.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }