Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT NO. 2 SPEAKER

FRONT NO. 2 SPEAKER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Door Lock)


    B088112
  1. Pull out the snap ring with a cloth as shown in the illustration, then remove the door window regulator handle assembly.



    B088113
  1. Remove the window regulator handle plate.



3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (w/ Power Door Lock)


B088093E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and clip, then remove the power window regulator master switch assembly.

  1. Disconnect the connector.



4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


B088092E01
  1. Disengage the 3 clips and remove the front door lower frame bracket garnish LH.

    NOTICE:
    Confirm that no clips remain on the door panel when the garnish is removed. Transfer any remaining clips to the garnish side before installing.



5. REMOVE FRONT DOOR TRIM PANEL ASSEMBLY LH


B088114E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 8 claws and remove the door assist grip cover LH.



    B088405E01
  1. Using a screwdriver with its tip wrapped in protective tape, open the cover.



    B088115
  1. Remove the 3 screws.



    B088116E01
  1. Disengage the 10 clips and remove the front door trim panel assembly LH.



6. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


E075954E01
  1. Disconnect the connector.

  1. Remove the 2 bolts.



    E075955
  1. Disengage the claw and remove the front No. 2 speaker assembly.