Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SPEAKER (for Access Cab)

REAR SPEAKER (for Access Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE LAP BELT OUTER ANCHOR COVER


B088402E01
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


B088403
  1. Remove the bolt and separate the outer front seat belt assembly LH (floor side).



    B088051E02
  1. Using a screwdriver with its tip wrapped in protective tape, open the cover.



    B088052
  1. Remove the screw, then remove the access panel inside handle bezel LH.



    B088053
  1. Remove the screw, then remove the door pull handle.



    B088054E02
  1. Remove the 10 clips.

  1. Remove the rear door trim board sub-assembly by sliding it upward.



4. REMOVE REAR ACCESS PANEL WEATHERSTRIP LH


B088050
  1. Remove the access panel rear weatherstrip LH.



5. REMOVE REAR SPEAKER ASSEMBLY


E075964E01
  1. Disconnect the connector.

  1. Remove the 3 screws and the rear speaker assembly.