Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR SPEAKER (for Double Cab)

REAR SPEAKER (for Double Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


B088069E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws, then pull out the rear power window regulator switch assembly by pulling it toward the front of the vehicle.

  1. Disconnect the connector, then remove the rear power window regulator switch assembly.



3. REMOVE REAR DOOR TRIM PANEL ASSEMBLY LH


B088070
  1. Remove the screw, then remove the door assist grip assembly LH.



    B088073E01
  1. Disengage the 9 clips.

  1. Remove the rear door trim panel assembly by sliding it upward.



4. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH


B088074E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage claw A as shown in the illustration.

  1. Move the rear door inside handle sub-assembly LH in the direction indicated by the arrow mark in the illustration. This will release the claw and allow the removal of the rear door inside handle sub-assembly LH.



    B088075
  1. Disconnect the 2 cables from the rear door inside handle sub-assembly LH.



5. REMOVE REAR SPEAKER ASSEMBLY


E075952E04
  1. Disconnect the connector.

  1. Remove the 3 screws and the rear speaker assembly.