Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA HOLDER

RADIO ANTENNA HOLDER > INSTALLATION

for Preparation Click here



1. INSTALL WITH HOLDER ANTENNA ASSEMBLY
  1. Tie the string inside the pillar to the new antenna assembly (with holder).

  1. Using the string, fit the antenna assembly (with holder) into the pillar.



    E075967E01
  1. Connect the connector and install the 3 clamps.



    E075968
  1. Install the antenna ornament with the nut.



    E075969
  1. Install the with holder antenna assembly with the bolt.



2. INSTALL PULL TOP ANTENNA POLE SUB - ASSEMBLY


E075993
  1. Install the pull top antenna pole sub-assembly by turning it clockwise.



3. INSTALL FRONT PILLAR GARNISH RH

HINT:
Follow the same procedures as for the front pillar garnish LH.



4. INSTALL ASSIST GRIP SUB-ASSEMBLY


B087423E01

HINT:
Follow the same procedures as for the opposite side.

  1. Install the assist grip with the 2 screws.



    B087431E01
  1. Engage the 2 claws and close the cover.



5. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH


    B085787E01
  1. Engage the 2 clips and install the instrument panel lower finish panel sub-assembly RH.

  1. Install the bolt <B>.



6. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    B085815E01
  1. Install the glow compartment door assembly with 3 hinges, holding it horizontal.



    B085785E01
  1. Slightly deform the upper part of the glove compartment door assembly, and install the glove compartment door assembly.

  1. Install the glove compartment door stopper onto the glove compartment door.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }