Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.


2. REMOVE NO. 2 LOWER STEERING WHEEL COVER


F052155E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the steering wheel cover lower No. 2.



3. REMOVE NO. 3 LOWER STEERING WHEEL COVER


F052156E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the No. 3 lower steering wheel cover.



4. REMOVE HORN BUTTON ASSEMBLY
  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference fits in the screw case.



    H042354
  1. Pull the steering pad out of the steering wheel assembly and support the steering pad with one hand, as shown in the illustration.

    NOTICE:
    When removing the steering pad, take care not to pull the airbag wire harness.

  1. Disconnect the horn ground harness from the steering pad.

  1. Using a screwdriver, disconnect the airbag connectors.



    F045013E01
  1. Remove the steering pad.

    CAUTION:
    1. When placing the steering pad assembly, keep the upper surface of the steering pad facing upward.
    2. Never disassemble the steering pad.



5. REMOVE STEERING PAD SWITCH LH


E062430E02
  1. Disconnect the connector.

  1. Remove the screw.



    E075999E01
  1. Disengage the 2 pins and remove the steering pad switch LH.



    E062433
  1. Release the tab of the steering pad switch cable from the steering pad switch LH as shown in the illustration.



    I034483E01
  1. Disengage the 2 claws and open the latch on the top of the connector as shown in the illustration.



    I034484
  1. Pull out the connector while pinching the latch with fingers and disconnect the steering pad switch cable from the steering pad switch LH.