Home › BODY › ENGINE HOOD / DOOR › HOOD

HOOD > DISASSEMBLY

for Preparation Click here


HINT:
For bolts without torque specifications, check the standard bolt chart (Click here).



1. REMOVE RADIATOR GRILLE


    B087564E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the 2 clips.

  1. Disengage the 2 clips and remove the radiator grille.



2. REMOVE NO. 2 HOOD LOCK RELEASE LEVER PROTECTOR


B088159


  1. Adjust the hood position.

    1. Loosen the 4 hinge bolts on the hood side.



    2. B088385E02
    3. Move the hood and adjust the clearance between the hood and front fender. Make sure that the clearance is within the standard range.

      Standard(A):
      4.4 +- 1.5 mm(0.173 +- 0.059 in.)

    4. Tighten the hood side hinge bolts after the adjustment.

      Torque:
      30N*m(306kgf*cm,22ft.*lbf)



    B088160
  1. Adjust the cushion rubber so that the heights of the hood and the fender are aligned.

    1. Raise or lower the hood front end by turning the cushion rubber. Make sure that the clearance is within the standard range.

      HINT:
      Raise or lower the cushion rubber by turning it.



    B088161
  1. Adjust the hood lock.

    1. Remove the 2 bolts and No. 2 hood lock release lever protector.



    2. B088162
    3. Loosen the 3 bolts.



    4. B088163
    5. Adjust the hood lock position so that the striker can enter it smoothly.



    6. B088162
    7. Tighten the 3 bolts after the adjustment.

      Torque:
      12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    8. B088161
    9. Install the No. 2 hood lock release lever protector.

      Torque:
      12 N*m{ 122 kgf*cm , 9 ft.*lbf }



3. REMOVE HOOD LOCK ASSEMBLY


B088162
  1. Remove the 3 bolts.



    B088389
  1. Disconnect the hood lock control cable assembly, then remove the hood lock assembly.



4. REMOVE HOOD SUPPORT


B088390E03
  1. Remove the hood support.

  1. Remove the grommet.



    B088391E02
  1. Using a clip remover, disengage the 2 claws and remove the hood stay holder.



5. REMOVE WASHER NOZZLE SUB-ASSEMBLY


B088392E01
  1. Disengage the 2 claws and remove the washer nozzle sub-assembly.

  1. Disconnect the washer hose.



6. REMOVE HOOD LOCK CONTROL CABLE PROTECTOR SUB-ASSEMBLY


B088393
  1. Remove the 2 nuts, then remove the hood lock control cable protector sub-assembly.



7. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


B088397E01
  1. Disengage the 2 claws.



    B088394
  1. Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.



8. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


B088395
  1. Tie a piece of string to the tip of the hood lock control cable assembly.

    HINT:
    Use a piece of string which is longer than the hood lock control cable assembly.



  1. Remove the hood lock control cable assembly referring to the illustration.


    B088396

    NOTICE:
    Leave the string inside the wire harness grommet for the installation of the hood lock control cable assembly.