Home › BODY › ENGINE HOOD / DOOR › HOOD

HOOD > REASSEMBLY

for Preparation Click here



1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY



B088396

  1. Tie the string inside the wire harness grommet to the hood lock control cable assembly.

  1. Using the string, fit the hood lock control cable assembly into the wire harness grommet.



2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


B088394
  1. Connect the hood lock control cable assembly.



    B088397E01
  1. Engage the 2 claws and install the hood lock control lever sub-assembly.



3. INSTALL HOOD LOCK CONTROL CABLE PROTECTOR SUB-ASSEMBLY


B088393
  1. Install the hood lock control cable protector sub-assembly with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



4. INSTALL WASHER NOZZLE SUB-ASSEMBLY


B088392E01
  1. Connect the washer hose.

  1. Engage the 2 claws and install the washer nozzle sub-assembly.



5. INSTALL HOOD SUPPORT


B088391E02
  1. Engage the 2 claws and install the hood stay holder.



    B088390E01
  1. Install the grommet.

  1. Install the hood support.



6. INSTALL HOOD LOCK ASSEMBLY


B088389
  1. Connect the hood lock control cable assembly.



    B088162
  1. Install the hood lock assembly with the 3 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



7. INSTALL NO. 2 HOOD LOCK RELEASE LEVER PROTECTOR


B088159


  1. Adjust the hood position.

    1. Loosen the 4 hinge bolts on the hood side.



    2. B088385E02
    3. Move the hood and adjust the clearance between the hood and front fender. Make sure that the clearance is within the standard range.

      Standard(A):
      4.4 +- 1.5 mm(0.173 +- 0.059 in.)

    4. Tighten the hood side hinge bolts after the adjustment.

      Torque:
      30N*m(306kgf*cm,22ft.*lbf)



    B088160
  1. Adjust the cushion rubber so that the heights of the hood and the fender are aligned.

    1. Raise or lower the hood front end by turning the cushion rubber. Make sure that the clearance is within the standard range.

      HINT:
      Raise or lower the cushion rubber by turning it.



    B088161
  1. Adjust the hood lock.

    1. Remove the 2 bolts and No. 2 hood lock release lever protector.



    2. B088162
    3. Loosen the 3 bolts.



    4. B088163
    5. Adjust the hood lock position so that the striker can enter it smoothly.



    6. B088162
    7. Tighten the 3 bolts after the adjustment.

      Torque:
      12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    8. B088161
    9. Install the No. 2 hood lock release lever protector.

      Torque:
      12 N*m{ 122 kgf*cm , 9 ft.*lbf }



8. INSTALL RADIATOR GRILLE


    B087564E01
  1. Engage the 2 clips and install the radiator grille.

  1. Install the 2 clips.

  1. Tighten the 2 screws.