FRONT DRIVE SHAFT (for 4WD) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT WHEEL |
| 3. DRAIN DIFFERENTIAL OIL |
| 4. SEPARATE FRONT SPEED SENSOR |
![]() |
Remove the bolt and separate the front speed sensor.
Disengage the 2 clamps.
Remove the bolt and separate the speed sensor wire harness from the steering knuckle.
| 5. SEPARATE TIE ROD END SUB-ASSEMBLY |
Remove the cotter pin and nut.
![]() |
Using SST, separate the tie rod end from the steering knuckle.
| 6. REMOVE FRONT AXLE HUB NUT |
![]() |
Using a screwdriver and a hammer, remove the front axle hub grease cap.
![]() |
Remove the cotter pin and adjusting cap.
Remove the front axle hub nut.
| 7. SEPARATE FRONT SUSPENSION LOWER ARM |
![]() |
Remove the 2 bolts and separate the front lower ball joint attachment front from the steering knuckle.
| 8. REMOVE FRONT DRIVE SHAFT |
![]() |
Using SST, remove the front drive shaft.