Home › DRIVE LINE › DRIVE SHAFT › FRONT DRIVE SHAFT (for 4WD)

FRONT DRIVE SHAFT (for 4WD) > DISASSEMBLY

for Preparation Click here



1. INSPECT FRONT DRIVE SHAFT


F052122
  1. Check whether there is no remarkable play in the outboard joint.

  1. Check whether the inboard joint slides smoothly in the thrust direction.

  1. Check whether there is no remarkable play in the radial direction of the inboard joint.

  1. Check the boots for damage.

    NOTICE:
    Move the drive shaft while keeping it level.



2. REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP


F052123
  1. Using pliers, disengage the hooks together and remove the large clamp.

  1. Using a side cutter, cut the small boot clamp.



3. SEPARATE INBOARD JOINT BOOT
  1. Slide the inboard joint boot toward the outboard joint.



4. REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY


F052150E01
  1. Place matchmarks on the inboard joint and outboard joint shaft.

    NOTICE:
    Do not punch the marks.

  1. Remove the inboard joint from the outboard joint shaft.



    G022501
  1. Using a snap ring expander, remove the snap ring.



    N000194E02
  1. Place matchmarks on the outboard joint shaft and tripod.

    NOTICE:
    Do not punch the marks.

  1. Using a brass bar and hammer, remove the tripod from the outboard joint shaft.

    NOTICE:
    Do not tap the roller.

  1. Remove the inboard joint boot from the outboard joint shaft.



5. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP
  1. Using a side cutter, cut the boot clamps.



6. REMOVE OUTBOARD JOINT BOOT
  1. Remove the outboard joint boot from the outboard joint shaft.



7. REMOVE FRONT DRIVE INNER SHAFT OUTER SHAFT SNAP RING


C057543
  1. Using a screwdriver, remove the snap ring.



8. REMOVE FRONT DRIVE SHAFT DUST COVER


F040647E01
  1. Using SST and a press, remove the dust cover.

    SST
    09950-00020  



9. REMOVE FRONT AXLE HUB OIL SEAL


C034791
  1. Using a screwdriver and a hammer, remove the oil seal.