Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB (for 2WD)

FRONT AXLE HUB (for 2WD) > DISASSEMBLY

for Preparation Click here



1. REMOVE KNUCKLE GREASE RETAINER CAP


C096928
  1. Using a screwdriver and a hammer, tap out the knuckle grease retainer cap.



2. REMOVE FRONT AXLE HUB NUT


C096931
  1. Using SST and a hammer, loosen the staked part of the lock nut.

    SST
    09930-00010  



    C096929
  1. Attach the 3 bolts onto the hub bolt in the position shown in the illustration, and screw them into the flange, then fix them in a vice.

  1. Using a socket wrench (36 mm), remove the lock nut.

  1. Remove the spacer.



3. REMOVE STEERING KNUCKLE


F052262E01
  1. Remove the 3 bolts and shift the dust cover towards the hub side (outside).

  1. Using SST, remove the steering knuckle.

    SST
    09710-30021   (09710-03131)
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04031, 09957-04010, 09958-04011)

  1. Remove the dust cover from the axle hub.



4. REMOVE FRONT AXLE HUB OIL SEAL
  1. Using a screwdriver, pry out the oil seal from the steering knuckle.



5. REMOVE FRONT AXLE HUB INNER BEARING


F052263E01
  1. Using snap ring pliers, remove the snap ring.

  1. Using SST and a press, press the bearing out of the steering knuckle.

    SST
    09950-60020   (09951-00710)
    09950-70010   (09951-07150)