Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB (for 2WD)

FRONT AXLE HUB (for 2WD) > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT AXLE HUB INNER BEARING


F052264E01
  1. Using SST and a press, press a new bearing into the steering knuckle.

    SST
    09527-17011  
    09608-10010  

  1. Using snap ring pliers, install a new snap ring.



2. INSTALL FRONT AXLE HUB OIL SEAL


C113894E01
  1. Using SST and a plastic-faced hammer, tap in a new oil seal.

    SST
    09223-15020  
    09527-17011  

  1. Coat MP grease to the oil seal lip.



3. INSTALL STEERING KNUCKLE


F052266E01
  1. Install the dust cover onto the steering knuckle with the 3 bolts.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }

  1. Using SST and a press, press in the axle hub to the steering knuckle.

    SST
    09710-30050  



4. INSTALL FRONT AXLE HUB NUT


C096929
  1. Attach the 3 bolts onto the hub bolt in the position shown in the illustration, and screw them into the flange, then fix them in a vice.

  1. Install the spacer.

  1. Using a socket wrench (36 mm), install a new lock nut onto the axle hub.

    Torque:
    199 N*m{ 2,029 kgf*cm , 147 ft.*lbf }

  1. Using a chisel and hammer, stake the lock nut.



5. INSTALL KNUCKLE GREASE RETAINER CAP


C096930
  1. Using a brass bar and hammer, install the knuckle grease retainer cap.

    NOTICE:
    Do not damage the knuckle grease retainer cap.