Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB (for 4WD and Pre-Runner)

FRONT AXLE HUB (for 4WD and Pre-Runner) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT WHEEL


3. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with painted surfaces.



4. SEPARATE FRONT SPEED SENSOR


F052163E03
  1. Remove the bolt and separate the speed sensor front LH.

  1. Disengage the 2 clamps.

  1. Remove the bolt and separate the speed sensor wire harness from the steering knuckle.



5. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY


F052164
  1. Remove the bolt and separate the brake tube bracket from the steering knuckle.



    F043120
  1. Using SST, disconnect the brake tube from the disc brake cylinder.

    SST
    09023-00101  

    NOTICE:
    Use a container to catch the brake fluid as it drains out.



    F043121
  1. Remove the 2 bolts and disc brake caliper.



6. REMOVE FRONT DISC


7. REMOVE FRONT AXLE HUB GREASE CAP (for 4WD)


F042729
  1. Using a screwdriver and a hammer, remove the front axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.



8. REMOVE FRONT AXLE HUB NUT (for 4WD)


F042732
  1. Remove the cotter pin and lock cap.

  1. Remove the front axle hub nut.



9. SEPARATE FRONT STABILIZER LINK ASSEMBLY


C099158
  1. Remove the nut and separate the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



10. SEPARATE TIE ROD END SUB-ASSEMBLY


F042735E01
  1. Remove the cotter pin and nut.

  1. Using SST, separate the tie rod end from the steering knuckle.

    SST
    09628-62011  



11. REMOVE FRONT SUSPENSION LOWER ARM


F051497
  1. Remove the 2 bolts, and separate the front suspension lower arm from the front axle.



12. SEPARATE FRONT SUSPENSION UPPER ARM


G020151E01
  1. Support the front suspension lower arm with a jack.

  1. Remove the clip and nut.

  1. Using SST, separate the steering knuckle from the front suspension upper arm.

    SST
    09628-62011  



13. REMOVE FRONT AXLE HUB
  1. for 4WD:

    1. Using a plastic hammer, separate the front axle hub from the front drive shaft.

  1. Remove the front axle hub.