Home › SUSPENSION & AXLE › AXLE › REAR AXLE SHAFT

REAR AXLE SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR AXLE SHAFT SNAP RING


F052133
  1. Using a snap ring expander, remove the snap ring.



2. REMOVE REAR AXLE SHAFT


F052134
  1. Using SST and press, remove the rear axle shaft.

    SST
    09521-25011  
    09521-25021  



3. REMOVE REAR AXLE BEARING RETAINER INNER
  1. Remove the rear axle bearing retainer inner from the rear axle bearing.



4. REMOVE REAR AXLE SHAFT WASHER
  1. Remove the rear axle shaft washer from the rear axle bearing.



5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


F052135
  1. Attach the 4 nuts to the rear axle housing bolts.

  1. Using a hammer, remove the 4 rear axle housing bolts and rear axle bearing.

    NOTICE:
    Do not reuse the nuts previously removed from the vehicle.



6. REMOVE REAR AXLE HUB BOLT


F052136E01
  1. for 2WD:

    1. Using SST, remove the 5 hub bolts.

      SST
      09650-17011  

  1. Remove the deflector and deflector gasket from the rear axle shaft.



    F042775E01
  1. for 4WD and Pre-Runner:

    1. Using SST, remove the 6 hub bolts.

      SST
      09650-17011  

  1. Remove the deflector and deflector gasket from the rear axle shaft.



7. REMOVE REAR AXLE BEARING OIL SEAL


F042797
  1. Grind the rear axle bearing inner race surface using a grinder, and then chisel them out with a chisel.

  1. Remove the rear axle shaft oil seal from the rear axle shaft.