Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB BOLT

REAR AXLE HUB BOLT > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


F040009
  1. Release the parking brake, and remove the rear brake drum.
    If the rear brake drum cannot be removed easily, perform the following procedures.

  1. Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjusting lever away from the adjuster.

  1. Using another screwdriver, contract the brake shoe by turning the adjusting bolt.

  1. Remove the drum gasket from the rear brake drum.



3. REMOVE FRONT BRAKE SHOE


F050540E01
  1. Using SST, remove the shoe return spring from the front brake shoe.

    SST
    09921-00010  



    F050541E01
  1. Using needle-nose pliers, remove the return spring.



    F050542E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.

    SST
    09718-00010  

  1. Remove the parking brake shoe strut lower.

  1. Remove the tension spring and front brake shoe.

  1. Remove the automatic adjust lever spring and automatic adjust lever LH from the front brake shoe.



4. REMOVE REAR BRAKE SHOE


F050543E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.

    SST
    09718-00010  



    F042688E01
  1. Using needle-nose pliers, disconnect the parking brake cable No. 3 and remove the rear brake shoe.



    F050544E01
  1. Using a screwdriver, remove the 2 C-washers, parking brake shoe lever, parking brake reaction lever and parking brake shoe strut set.



5. REMOVE REAR AXLE HUB BOLT


C114965E01
  1. Using SST, remove the hub bolt.

    SST
    09650-17011