STOP LIGHT SWITCH > INSPECTION |
| 1. INSPECT STOP LIGHT SWITCH |
![]() |
Check the resistance.
Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1-2 | Switch pin free | Below 1 Ω |
| 3-4 | Switch pin free | 10 kΩ or higher |
| 1-2 | Switch pin pushed in | 10 kΩ or higher |
| 3-4 | Switch pin pushed in | Below 1 Ω |