Home › BODY ELECTRICAL › LIGHTING › FRONT DOOR COURTESY SWITCH

FRONT DOOR COURTESY SWITCH > INSPECTION

for Preparation Click here



1. INSPECT FRONT DOOR COURTESY SWITCH
  1. Check the resistance.

    1. Measure the resistance using an ohmmeter, and check the results in accordance with the value( s) in the table below.

      Standard:

      Tester Connection
      Condition
      Specified Condition
      1-Switch body
      ON (When shaft is pressed)
      10 kΩ or higher
      1-Switch body
      OFF (When shaft is not pressed)
      Below 1 Ω

      If the result is not as specified, replace the front door courtesy light switch assembly.