Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY


E068372E06
  1. Engage the 2 claws and install the headlight dimmer switch assembly as shown in the illustration.



    I037768E05
  1. Install the headlight dimmer switch assembly with the clamp.

  1. Connect the connector.



2. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY


E076074E01
  1. Engage the claw and install the windshield wiper switch assembly.

  1. Connect the 2 connectors.



3. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Set the turn signal switch in neutral position.

    NOTICE:
    Make sure of the neutral position since the pin of the turn signal switch may be snapped.

  1. Install the spiral cable sub-assembly with the 4 screws.

    NOTICE:
    When replacing the spiral cable sub-assembly with a new one, remove the lock pin before installing the handle.

  1. Connect the airbag connector and connector.

  1. Install the steering column cover with the 3 screws.



4. INSTALL STEERING COLUMN UPPER COVER
  1. Engage the claw and then install the steering column cover upper.



5. INSTALL STEERING COLUMN LOWER COVER
  1. Engage the 2 claws.

  1. Install the steering column cover lower with the 2 screws.



6. CENTER SPIRAL CABLE
  1. Check that the ignition switch is OFF.

  1. Check that the cable is disconnected from the negative battery terminal.

    NOTICE:
    Do not start the operation for 90 seconds after disconnecting the cable from the negative battery terminal.



    F051312
  1. Turn the cable counterclockwise by hand until it becomes harder to turn.



    F051313E01
  1. Turn the cable clockwise about 2.5 turns to align the marks.

    HINT:
    The cable will rotate about 2.5 turns both left and right from the center.



7. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel assembly and steering main shaft assembly.

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



8. INSPECT STEERING WHEEL CENTER POINT


9. INSPECT HORN BUTTON ASSEMBLY


10. INSTALL HORN BUTTON ASSEMBLY


11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



12. INSPECT SRS WARNING LIGHT


13. INSTALL NO. 3 STEERING WHEEL LOWER COVER
  1. Engage the 2 claws, install the No. 3 lower steering wheel cover to the steering wheel assembly.



14. INSTALL NO. 2 STEERING WHEEL LOWER COVER
  1. Engage the 2 claws, install the No. 2 lower steering wheel cover to the steering wheel assembly.