Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY


E076075E01
  1. Check the resistance of the light control switch.

    1. Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in the table below.

      Standard:
      Tester Connection
      Condition
      Specified Condition
      -
      OFF
      10 kΩ or higher
      12-18
      TAIL
      Below 1Ω
      12-18-20
      HEAD
      Below 1Ω

      If the result is not as specified, replace the headlight dimmer switch assembly.

  1. Check the resistance of the headlight dimmer switch.

    1. Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in the table below.

      Standard:
      Tester Connection
      Condition
      Specified Condition
      11-12-17
      FLASH
      Below 1Ω
      12-16
      LOW BEAM
      Below 1Ω
      11-12
      HI BEAM
      Below 1Ω

      If the result is not as specified, replace the headlight dimmer switch assembly.

  1. Check the resistance of the turn signal switch.

    1. Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in the table below.

      Standard:
      Tester Connection
      Condition
      Specified Condition
      12-13
      Right turn
      Below 1Ω
      -
      Neutral
      10 kΩ or higher
      12-15
      Left turn
      Below 1Ω

      If the result is not as specified, replace the headlight dimmer switch assembly.