Home › BODY ELECTRICAL › LIGHTING › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HAZARD WARNING SWITCH


E076077E01
  1. Check the resistance.

    1. Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in the table below.

      Standard:
      Tester Connection
      Condition
      Specified Condition
      7-9
      OFF
      10 kΩ or higher
      7-9
      ON
      Below 1 Ω
      10-11
      Illumination circuit
      Below 1 Ω

      If the result is not as specified, replace the hazard warning signal switch assembly.

  1. Check the illumination operation.

    1. (1) Connect the battery positive (+) lead to terminal 11 and the battery negative (-) lead to terminal 10, then check that the illumination comes on.

      Standard:
      Illumination comes on.

      If the illumination does not come on, replace the bulb.