FRONT WIPER MOTOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT WIPER ARM HEAD CAP |
![]() |
Using a screwdriver wrapped with protective tape, remove the 2 front wiper arm head caps.
| 3. REMOVE FRONT WIPER ARM LH |
![]() |
Operate the wiper, then stop the windshield wiper motor assembly at the automatic stop position.
Remove the nut and front wiper arm LH.
| 4. REMOVE FRONT WIPER ARM RH |
| 5. REMOVE FRONT FENDER TO COWL SIDE SEAL LH |
![]() |
Disengage the 2 claws and remove the front fender to cowl side seal LH.
| 6. REMOVE FRONT FENDER TO COWL SIDE SEAL RH |
| 7. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY |
![]() |
Disengage the 2 clips.
Disengage the 15 claws, then remove the cowl top ventilator louver sub-assembly.
| 8. REMOVE WINDSHIELD WIPER MOTOR AND LINK |
![]() |
Disconnect the connector, then remove the 2 bolts.
Slide the wiper link assembly to the passenger side seat side. Disengage the meshing of the rubber pin, then remove the windshield wiper motor & link assembly.
| 9. REMOVE FRONT WIPER MOTOR |
![]() |
Using a screwdriver wrapped with protective tape, disengage the meshing of the 2 rods at the crank arm pivot of the windshield wiper motor assembly.
![]() |
Using a "Torx" socket wrench (T30), remove the 2 screws and windshield wiper motor assembly.