Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER SWITCH

WIPER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT WIPER SWITCH


E113070E01
  1. Check the resistance.

    1. Measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard:
      Wiper Switch
      Tester connection
      Condition
      Specified condition
      +B(E7-2) - +1(E7-3)
      MIST
      Below 1 Ω
      +S(E7-1) - +1(E7-3)
      OFF
      Below 1 Ω
      +S(E7-1) - +1(E7-3)
      INTO
      Below 1 Ω
      +B(E7-2) - +1(E7-3)
      LO
      Below 1 Ω
      +B(E7-2) - +2(E7-4)
      HI
      Below 1 Ω

      If the result is not as specified, replace the windshield wiper switch assembly.

      Standard:
      Washer Switch
      Tester connection
      Condition
      Specified condition
      EW(E11-2) - WF(E11-3)
      OFF
      10 kΩ or higher
      EW(E11-2) - WF(E11-3)
      ON
      Below 1 Ω

      If the result is not as specified, replace the windshield wiper switch assembly.



  1. Check the intermittent operation.

    1. Connect the voltmeter positive terminal to terminal 3 (+1) of the E7 connector and the voltmeter negative terminal to terminal 2 (EW) of the E11 connector.

    2. Connect the battery positive (+) lead to terminal 2 (+B) of the E7 connector and the battery negative (-) lead to terminals 2 (EW) of the E11 connector and 1 (+S) of the E7 connector.

    3. Turn the wiper switch to the INT position.

    4. Connect the battery positive (+) lead to terminal 1 (+S) of the E7 connector for 5 seconds.



    5. Connect the battery negative lead to terminal 1 (+S) of the E7 connector. Operate the intermittent wiper relay and check the voltage between terminals 3 (+1) of the E7 connector and 2 (EW) of the E11 connector.


      E113071E01



  1. Check the operation


    E113072E01


    1. Turn the wiper switch off.

    2. Connect the battery positive lead to terminal 2 (+B) of the E7 connector and the battery negative lead to terminals 1 (+S) of the E7 connector and 2 (EW) of the E11 connector.

    3. Connect the voltmeter positive terminal to terminal 3 (+1) of the E7 connector and the voltmeter negative terminal to terminal 2 (EW) of the E11 connector. Turn the washer switch on and off, and check the voltage between terminals 3 (+1) of the E7 connector and 2 (EW) of the E11 connector.