Home › BODY › WINDSHIELD / WINDOWGLASS › QUARTER WINDOW GLASS (for Access Cab)

QUARTER WINDOW GLASS (for Access Cab) > REMOVAL

for Preparation Click here



1. REMOVE REAR ACCESS PANEL WEATHERSTRIP


B088050
  1. Remove the access panel rear weatherstrip LH.



2. REMOVE LAP BELT OUTER ANCHOR COVER


B088402E01
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


B088403
  1. Remove the bolt and separate the outer front seat belt assembly LH (floor side).



    B088051E02
  1. Using a screwdriver with its tip wrapped in protective tape, open the cover.



    B088052
  1. Remove the screw, then remove the access panel inside handle bezel LH.



    B088053
  1. Remove the screw, then remove the door pull handle.



    B088054E02
  1. Remove the 10 clips.

  1. Remove the rear door trim board sub-assembly by sliding it upward.



4. REMOVE REAR DOOR GLASS SUB-ASSEMBLY


B087543E01
  1. Apply protective tape to the outer circumference of the quarter window, as shown in the illustration.

  1. From the interior, insert piano wires between the vehicle body and quarter window, as shown in the illustration.

  1. When separating the quarter window from the vehicle, be careful not to damage the vehicle's paint or exterior/interior ornaments.

    NOTICE:
    When separating the quarter window from the vehicle, be careful not to damage the vehicle's paint or exterior/interior ornaments.

  1. Cut through the adhesive by pulling the piano wire around the quarter window.