Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSTALLATION

for Preparation Click here



1. REMOVE OUTER REAR VIEW MIRROR


B087558E01
  1. Engage the 2 claws into the outer rear view mirror.

  1. Engage the 2 claws and install the outer rear view mirror.



2. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


B087556E01
  1. Engage the claw and install the outer rear view mirror.

  1. Tighten the 3 nuts.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf }

  1. Connect the outer rear view mirror connector (w/ Power Mirror).



3. REMOVE FRONT DOOR TRIM PANEL ASSEMBLY (w/ Power Window)


B088097E01
  1. Engage the 10 clips and install the front door trim panel assembly LH.



    B088096
  1. Install the 2 screws.



    B088406
  1. Close the cover.



4. REMOVE FRONT DOOR TRIM PANEL ASSEMBLY (w/o Power Window)


B088116E01
  1. Engage the 10 clips and install the front door trim panel assembly LH.



    B088115
  1. Install the 3 screws.



    B088114E01
  1. Engage the 8 claws and install the door assist grip cover LH.



    B088406
  1. Close the cover.



5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Double Cab)


B088412E01
  1. Connect the connector.

  1. Engage the 3 claws and clip, and install the power window regulator master switch assembly.



6. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Access Cab)


B088413E01
  1. Connect the connector.

  1. Engage the 3 claws and clip, and install the power window regulator master switch assembly.



7. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY


B088407E01
  1. Install the window regulator handle plate.



    B088408E01
  1. Install the front door window regulator handle assembly with the snap ring.



8. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/ Power Window)


B088092E01
  1. Engage the 3 clips and install the front lower frame bracket garnish LH.

    NOTICE:
    Confirm that no clips remain on the door panel before the garnish is installed. Transfer any remaining clips to the garnish side before installing it. Installing the garnish with any clips remaining on the door panel side could cause the clips to drop inside the door panel.



9. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/o Power Window)


B088092E01
  1. Engage the 3 clips and install the front door lower frame bracket garnish LH.

    NOTICE:
    Confirm that no clips remain on the door panel before the garnish is installed. Transfer any remaining clips to the garnish side before installing it. Installing the garnish with any clips remaining on the door panel side could cause the clips to drop inside the door panel.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }