OUTER REAR VIEW MIRROR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/ Power Window) |
![]() |
Disengage the 3 clips and remove the front door lower frame bracket garnish LH.
| 3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (w/o Power Window) |
![]() |
Disengage the 3 clips and remove the front door lower frame bracket garnish LH.
| 4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY |
![]() |
Pull out the snap ring with a cloth as shown in the illustration, then remove the door window regulator handle assembly.
![]() |
Remove the window regulator handle plate.
| 5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Double Cab) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and clip, then remove the power window regulator master switch assembly.
Disconnect the connector.
| 6. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Access Cab) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and clip, then remove the power window regulator master switch assembly.
Disconnect the connector.
| 7. REMOVE FRONT DOOR TRIM PANEL ASSEMBLY (w/ Power Window) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, open the cover.
![]() |
Remove the 2 screws.
![]() |
Disengage the 10 clips and remove the front door trim panel assembly LH.
| 8. REMOVE FRONT DOOR TRIM PANEL ASSEMBLY (w/o Power Window) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 8 claws and remove the door assist grip cover LH.
![]() |
Using a screwdriver with its tip wrapped in protective tape, open the cover.
![]() |
Remove the 3 screws.
![]() |
Disengage the 10 clips and remove the front door trim panel assembly LH.
| 9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY |
![]() |
Disconnect the outer rear view mirror connector (w/ Power mirror).
Remove the 3 nuts.
Disengage the claw and remove the outer rear view mirror.
| 10. REMOVE OUTER REAR VIEW MIRROR |
![]() |
Apply protective tape to the outer circumference of the outer rear view mirror, as shown in the illustration.
Using a screwdriver with its tip taped in protective tape, disengage the 2 claws.
Disengage the 2 claws and remove the outer rear view mirror.