Home › SUSPENSION & AXLE › AXLE › AXLE SYSTEM

AXLE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT AXLE HUB BEARING


F042745
  1. Remove the front wheel.

  1. for 4WD:

    1. Remove the front axle hub grease cap .

  1. for 2WD:

    1. Remove the front disc brake caliper .

  1. for 4WD and Pre-Runner

    1. Remove the front disc brake caliper .

  1. Remove the front disc.

  1. Inspect the axle hub backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the bearing.



    F042746
  1. Inspect the axle hub deviation.

    1. Using a dial indicator, check the distortion of the surface of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the deviation exceeds the maximum, replace the bearing.



2. INSPECT REAR AXLE HUB BEARING


F052148
  1. Remove the rear wheel.

  1. Remove the rear brake drum .

  1. Inspect the axle shaft backlash.

    1. Using a dial indicator, check the backlash near the center of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the bearing.



    F052149
  1. Inspect the axle shaft deviation.

    1. Using a dial indicator, check the distortion of the surface of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the deviation exceeds the maximum, replace the bearing.