LUBRICATION SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK ENGINE OIL LEVEL |
Warm up the engine, then stop the engine and wait for 5 minutes. Check that the engine oil level is between low and full marks on the oil level gage.
If the engine oil level is low, check for oil leakage and add engine oil up to the full level mark.
| 2. CHECK ENGINE OIL QUALITY |
![]() |
Check the oil for deterioration, water intrusion, discoloration or thinning.
If the quality is visibly poor, replace the oil.
| 3. INSPECT OIL PRESSURE |
![]() |
Remove the 4 bolts, then remove the No. 1 engine under cover. (PRE RUNNER AND 4WD TYPE)
Disconnect the oil pressure switch connector.
Using a 24 mm deep socket wrench, remove the oil pressure switch.
![]() |
Install the oil pressure gauge.
Warm up the engine.
Inspect the oil pressure.
| When Idling | 29 kPa (0.3 kgf*cm2, 4.2 psi) or more |
| At 3,000 rpm | 160 to 490 kPa (1.6 to 5.3 kgf*cm2, 23 to 75 psi) |
Remove the oil pressure gauge.
![]() |
Apply adhesive to 2 or 3 threads of the oil pressure switch.
Using a 24 mm deep socket wrench, install the oil pressure switch.
Connect the oil pressure switch connector.
Check for engine oil leakage.
Install the engine under cover No. 1 with the 4 bolts. (PRE RUNNER AND 4WD TYPE)