Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold tire inflation pressure:

    Tire Size
    Front Wheel
    kPa (kgf/cm2, psi)
    Rear Wheel
    kPa (kgf/cm2, psi)
    Spare Wheel
    kPa (kgf/cm2, psi)
    P215/70R15 97S
    200 (2.0, 29)
    220 (2.2, 32)
    220 (2.2, 32)
    P255/45R18 99V
    240 (2.4, 35)
    240 (2.4, 35)
    240 (2.4, 35)
    P245/75R16 109S
    200 (2.0, 29)
    200 (2.0, 29)
    200 (2.0, 29)
    P265/70R16 111T
    200 (2.0, 29)
    220 (2.2, 32)
    220 (2.2, 32)
    P265/65R17 110S
    200 (2.0, 29)
    200 (2.0, 29)
    200 (2.0, 29)



    R003031
  1. Using a dial indicator, check the tire runout.

    Tire runout:
    3.0 mm (0.118 in.) or less



2. ROTATE TIRES


G022181E01

HINT:
See the illustration on the left for how to rotate the tires, when you include the spare tire in the rotation.



3. INSPECT WHEEL BALANCE


C080976
  1. Perform off-car balancing.

  1. If necessary, perform on-car balancing.

    Imbalance after adjustment:
    8 g (0.018 lb) or less



4. INSPECT FRONT AXLE HUB BEARING


F042745
  1. Remove the front wheel.

  1. for 4WD:

    1. Remove the front axle hub grease cap .

  1. for 2WD:

    1. Remove the front disc brake caliper .

  1. for 4WD and Pre-Runner

    1. Remove the front disc brake caliper .

  1. Remove the front disc.

  1. Inspect the axle hub backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the bearing.



    F042746
  1. Inspect the axle hub deviation.

    1. Using a dial indicator, check the distortion of the surface of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the deviation exceeds the maximum, replace the bearing.



5. INSPECT REAR AXLE HUB BEARING


F052148
  1. Remove the rear wheel.

  1. Remove the rear brake drum .

  1. Inspect the axle shaft backlash.

    1. Using a dial indicator, check the backlash near the center of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the bearing.



    F052149
  1. Inspect the axle shaft deviation.

    1. Using a dial indicator, check the distortion of the surface of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the deviation exceeds the maximum, replace the bearing.