Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT BRAKE SHOE


F050540E01
  1. Using SST, remove the shoe return spring from the front brake shoe.

    SST
    09921-00010  



    F050541E01
  1. Using needle-nose pliers, remove the return spring.



    F050542E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.

    SST
    09718-00010  

  1. Remove the parking brake shoe strut lower.

  1. Remove the tension spring and front brake shoe.

  1. Remove the automatic adjust lever spring and automatic adjust lever LH from the front brake shoe.



2. REMOVE REAR BRAKE SHOE


F050543E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.

    SST
    09718-00010  



    F042688E01
  1. Using needle-nose pliers, disconnect the parking brake cable No. 3 and remove the rear brake shoe.



    F050544E01
  1. Using a screwdriver, remove the 2 C-washers, parking brake shoe lever, parking brake reaction lever and parking brake shoe strut set.



3. REMOVE FRONT OR UPPER REAR WHEEL BRAKE CYLINDER ASSEMBLY


F050546E01
  1. Using SST, disconnect the brake tube, and use a container to collect the brake fluid as it flows out.

    SST
    09023-00101  

  1. Remove the 2 bolts and rear wheel brake cylinder assembly.



4. REMOVE REAR WHEEL CYLINDER CUP KIT
  1. Remove the 2 wheel cylinder boots from the rear wheel brake cylinder.

  1. Remove the 2 pistons and compression spring.

  1. Remove the 2 cylinder cups from each piston.

  1. Remove the bleeder plug cap and bleeder plug from the rear wheel brake cylinder.