Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (w/o VSC)

BRAKE MASTER CYLINDER (w/o VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. REMOVE BRAKE MASTER CYLINDER


F050566
  1. Disconnect the brake fluid level warning switch connector.

  1. for Manual Transmission:

    1. Disconnect the clutch reservoir tube from the reservoir.



    F050567
  1. Using SST, disconnect the 2 brake lines from the brake master cylinder.

    SST
    09023-00101  



    F050568
  1. Remove the 2 nuts, then pull the brake master cylinder out of the brake booster.

  1. Remove the O-ring from the brake master cylinder.