Home › BRAKE › BRAKE › BRAKE BOOSTER (w/o VSC)

BRAKE BOOSTER (w/o VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. REMOVE FRONT FLOOR FOOTREST


    B087437E01
  1. Disengage the 2 clips and remove the front floor footrest.



4. REMOVE FRONT DOOR SCUFF PLATE (for Regular Cab)


    B087476E01
  1. Disengage the 8 claws and clip, and remove the front door scuff plate.



5. REMOVE FRONT DOOR SCUFF PLATE (for Access Cab)


    B087436E01
  1. Disengage the 9 claws and clip, and remove the front door scuff plate.



6. REMOVE FRONT DOOR SCUFF PLATE (for Double Cab)


    B087411E01
  1. Disengage the 9 claws and remove the front door scuff plate.



7. REMOVE COWL SIDE TRIM BOARD (for Regular Cab)


    B087438E01
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim board.



8. REMOVE COWL SIDE TRIM BOARD (for Access Cab)


    B087438E01
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim board.



9. REMOVE COWL SIDE TRIM BOARD (for Double Cab)


    B087438E01
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim board.



10. REMOVE INSTRUMENT PANEL UNDER TRAY (for Automatic Transmission)


    B085766E01
  1. Disengage the 4 clips and 2 claws, and remove the instrument panel under tray.



11. REMOVE INSTRUMENT PANEL HOLE COVER (for Manual Transmission)


    B085767E01
  1. Disengage the 4 clips and remove the instrument panel hole cover.



12. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO. 1


    B085780E01
  1. Remove the 2 bolts <B>.

  1. Disengage the 3 clips and remove the lower No. 1 instrument panel finish panel.

  1. Disconnect the connectors.



13. SEPARATE DRIVER SIDE JUNCTION BLOCK


14. REMOVE BRAKE MASTER CYLINDER


F050566
  1. Disconnect the brake fluid level warning switch connector.

  1. for Manual Transmission:

    1. Disconnect the clutch reservoir tube from the reservoir.



    F050567
  1. Using SST, disconnect the 2 brake lines from the brake master cylinder.

    SST
    09023-00101  



    F050568
  1. Remove the 2 nuts, then pull the brake master cylinder out of the brake booster.

  1. Remove the O-ring from the brake master cylinder.



15. SEPARATE MASTER CYLINDER PUSH ROD CLEVIS


F050561
  1. Remove the clip and push rod pin, then separate the push rod clevis.



16. REMOVE BRAKE BOOSTER


F050572
  1. Disconnect the vacuum hose from the brake booster.



    F050571
  1. Remove the 4 nuts, and pull out the brake booster.

  1. Remove the gasket from the brake booster.