BRAKE BOOSTER (w/o VSC) > ON-VEHICLE INSPECTION |
| 1. INSPECT BRAKE BOOSTER |
![]() |
Check the air tightness.
Start the engine and stop it after 1 or 2 minutes. Depress the brake pedal several times slowly.
Depress the brake pedal while the engine is running, and stop the engine with the pedal depressed.
![]() |
Check the operation.
Depress the brake pedal several times with the ignition switch at OFF and check that there is no change in the pedal reserve distance.
Depress the brake pedal and start the engine.
| 2. INSPECT VACUUM CHECK VALVE |
Check the vacuum check valve.
Slide the clip and disconnect the vacuum hose.
Remove the vacuum check valve.
![]() |
Check that there is ventilation from the booster to the engine, and no ventilation from the engine to the booster.
If any fault is found, replace the vacuum check valve.