Home › STEERING › POWER STEERING › VANE PUMP (for 2TR-FE)

VANE PUMP (for 2TR-FE) > INSTALLATION

for Preparation Click here



1. INSTALL VANE PUMP


F051265
  1. Install the vane pump assembly with the 2 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



    F051264
  1. Connect the oil pressure switch connector.

    NOTICE:
    Make sure that no oil adheres to the connector.



2. CONNECT PRESSURE FEED TUBE ASSEMBLY


F051263
  1. Install a new gasket onto the pressure feed tube.

  1. Install the pressure feed tube with the union bolt.

    Torque:
    51 N*m{ 520 kgf*cm , 38 ft.*lbf }



    F051262
  1. Connect the return hose with the clip.



3. INSTALL FAN AND GENERATOR V BELT


G038204E01
  1. Provisionally install the V belt onto each pulley.

    NOTICE:
    Install the V belt onto each pulley and finally install the V belt onto the V-ribbed belt tensioner.

  1. Turn the hexagonal bolt on the V-ribbed belt tensioner clockwise and install the V belt onto the V-ribbed belt tensioner pulley.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

(Click here)


5. ADD POWER STEERING FLUID


6. BLEED POWER STEERING FLUID
  1. Check the fluid level.

  1. Jack up the front of the vehicle and support it with stands.

  1. Turn the steering wheel.

    1. With the engine stopped, turn the wheel slowly from lock to lock several times.

  1. Lower the vehicle.

  1. Start the engine.

    1. Run the engine at idle for a few minutes.

  1. Turn the steering wheel.

    1. With the engine idling, turn the wheel to the left or right full lock position and keep it there for 2 to 3 seconds. Then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds (step A).

    2. Repeat step A several times.

  1. Stop the engine.



    C114971E01
  1. Check for foaming or emulsification.
    Especially, if the system has to be bled twice because of foaming or emulsification, check for fluid leakage in the system.

  1. Check the fluid level.



7. CHECK POWER STEERING FLUID LEAKAGE


8. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO. 1 (for 4WD and Pre-Runner)

Torque:
30 N*m{ 306 kgf*cm , 22 ft.*lbf }