VANE PUMP (for 2TR-FE) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO. 1 (for 4WD and Pre-Runner) |
| 3. REMOVE FAN AND GENERATOR V BELT |
![]() |
Turning the hexagonal bolt on the V-ribbed belt tensioner clockwise, loosen and then remove the V belt.
| 4. DRAIN POWER STEERING FLUID |
| 5. DISCONNECT PRESSURE FEED TUBE ASSEMBLY |
![]() |
Disengage the clip and disconnect the return hose.
![]() |
Remove the union bolt, then disconnect the pressure feed tube.
Remove the gasket from the pressure feed tube.
| 6. REMOVE VANE PUMP |
![]() |
Disconnect the oil pressure switch connector.
![]() |
Remove the 2 bolts and vane pump assembly.