Home › STEERING › POWER STEERING › VANE PUMP (for 1GR-FE)

VANE PUMP (for 1GR-FE) > DISASSEMBLY

for Preparation Click here



1. FIX VANE PUMP


F042477E01
  1. Using SST, fix the vane pump assembly in a vise.

    SST
    09630-00014   (09631-00132)

    NOTICE:
    When using a vise, do not over tighten it.



2. REMOVE POWER STEERING SUCTION PORT UNION
  1. Remove the bolt and suction port union.

  1. Remove the O-ring from the suction port union.



3. REMOVE FLOW CONTROL VALVE
  1. Remove the pressure port union.

  1. Remove the O-ring from the pressure port union.

  1. Remove the flow control valve and compression spring.



4. REMOVE POWER STEERING OIL PRESSURE SWITCH

NOTICE:
Be careful not to drop or badly damage the oil pressure switch. If damaged, replace it with a new one.



5. REMOVE VANE PUMP HOUSING REAR
  1. Remove the 4 bolts and vane pump housing rear from the vane pump housing front.

  1. Remove the O-ring from the vane pump housing front.



6. REMOVE PULLEY SHAFT SUB-ASSEMBLY

NOTICE:
Be careful not to drop or badly damage the pulley shaft. If damaged, replace it with a new one.

  1. Using a screwdriver, remove the snap ring from the pulley shaft.

  1. Remove the pulley shaft.



7. REMOVE VANE PUMP ROTOR
  1. Remove the 10 vane plates.

  1. Remove the vane pump rotor.



8. REMOVE VANE PUMP CAM RING


9. REMOVE VANE PUMP SIDE PLATE FRONT


C065368
  1. Remove the side plate from the vane pump housing front.

  1. Remove the O-ring from the side plate.



    F051267
  1. Remove the O-ring from the vane pump housing front.



10. REMOVE VANE PUMP HOUSING OIL SEAL


F051268
  1. Using screwdriver, remove the oil seal.

    NOTICE:
    Be careful not to damage the vane pump housing front.