Home › STEERING › POWER STEERING › POWER STEERING LINK (for 2WD)

POWER STEERING LINK (for 2WD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. REMOVE FRONT WHEELS


4. REMOVE STEERING INTERMEDIATE SHAFT NO. 2


F051676
  1. Fix the steering wheel with the seat belt in order to prevent it from rotating.

    HINT:
    The operation is effective for preventing any damage to the spiral cable.



    F051677E01
  1. Place matchmarks on the steering sliding yoke, steering intermediate shaft No. 2 and steering intermediate shaft.

  1. Remove bolts A and B from the steering sliding yoke.

  1. Slide the steering sliding yoke up and separate it from the steering intermediate shaft No. 2.

  1. Pull down the steering sliding yoke from the steering intermediate shaft to remove it.



    F051678E01
  1. Place matchmarks on the steering intermediate shaft No. 2 and power steering link.

  1. Remove bolt C from the steering intermediate shaft No. 2.

  1. Slide the steering intermediate shaft No. 2 up and remove it from the power steering link.



5. SEPARATE TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and nut.



    F051689E01
  1. Using SST, separate the tie rod end from the steering knuckle arm.

    SST
    09610-20012  



6. SEPARATE TIE ROD END SUB-ASSEMBLY RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



7. SEPARATE PRESSURE FEED TUBE ASSEMBLY


C114973E01
  1. Remove the bolt and separate the tube support bracket.



    F051682E01
  1. Using SST, loosen the flare nut and separate the pressure feed tube.

    SST
    09023-12701  



    F051683
  1. Disengage the clip and disconnect the return hose.



8. REMOVE POWER STEERING LINK


F051692
  1. Remove the 2 bolts, 2 nuts and power steering link.

    NOTICE:
    The nut has a detent, so never turn the nut. Be sure to turn only the bolt.