POWER STEERING LINK (for 4WD and Pre-Runner) > DISASSEMBLY |
| 1. REMOVE STEERING GEAR OUTLET RETURN TUBE |
![]() |
Using SST, remove the return tube.
| 2. REMOVE STEERING TURN PRESSURE TUBE |
![]() |
Using SST, remove the 2 pressure tubes.
Remove the 4 O-rings from the pressure tubes.
| 3. FIX POWER STEERING LINK |
![]() |
Using SST, fix the power steering link between aluminium plates in a vise, as shown in the illustration.
| 4. REMOVE TIE ROD END SUB-ASSEMBLY LH |
![]() |
Place matchmarks on the tie rod end, lock nut and rack end.
Loosen the lock nut and remove the tie rod end and lock nut.
| 5. REMOVE TIE ROD END SUB-ASSEMBLY RH |
| 6. REMOVE STEERING RACK BOOT CLIP |
Remove the 2 rack boot clips.
| 7. REMOVE STEERING RACK BOOT NO. 1 CLAMP |
Using pliers, remove the rack boot No. 1 clamp.
| 8. REMOVE STEERING RACK BOOT NO. 2 CLAMP |
| 9. REMOVE STEERING RACK BOOT NO. 1 |
| 10. REMOVE STEERING RACK BOOT NO. 2 |
| 11. REMOVE STEERING RACK END SUB-ASSEMBLY |
![]() |
Using a screwdriver and hammer, unstake the claw washer.
![]() |
Using 2 SSTs, remove the 2 steering rack ends and 2 claw washers.
| 12. REMOVE STEERING GEAR RACK GUIDE |
![]() |
Using SST, remove the rack guide spring cap nut.
![]() |
Using SST, remove the rack guide spring cap.
Remove the rack guide spring and rack guide.
| 13. REMOVE POWER STEERING CONTROL VALVE ASSEMBLY |
![]() |
Wind vinyl tape around the serrated portion of the control valve.
Remove the dust cover from the control valve housing.
![]() |
Remove the 2 bolts and the control valve w/ control valve housing.
Remove the O-ring from the control valve housing.
![]() |
To prevent the oil seal lip from getting damaged, wind vinyl tape around the serrated portion of the control valve.
Using a plastic hammer, remove the control valve from the control valve housing.
![]() |
Using a screwdriver, remove the 4 control valve rings.
| 14. REMOVE POWER STEERING CONTROL VALVE UPPER OIL SEAL |
![]() |
Using SST and a press, remove the control valve upper bearing and control valve upper oil seal from the control valve housing.
| 15. REMOVE CYLINDER END STOPPER |
![]() |
Using a screwdriver and hammer, turn the cylinder end stopper clockwise until the wire end can be seen through the service hole.
Using a screwdriver and hammer, turn the cylinder end stopper counterclockwise, and remove the wire and cylinder end stopper.
| 16. REMOVE POWER STEERING RACK |
| 17. REMOVE POWER STEERING RACK BUSH |
Remove the rack bush from the power steering rack.
Using a screwdriver, remove the O-ring from the rack bush.
![]() |
Using SST, remove the rack bush oil seal.
| 18. REMOVE POWER STEERING CYLINDER TUBE OIL SEAL |
![]() |
Using SST and a press, remove the cylinder tube oil seal.
| 19. REMOVE RACK STEERING PISTON RING |
![]() |
Using a screwdriver, remove the piston ring and O-ring.