Home › TRANSMISSION ยท CLUTCH › CLUTCH MASTER CYLINDER

CLUTCH MASTER CYLINDER > REMOVAL

for Preparation Click here



1. DRAIN CLUTCH FLUID


2. DISCONNECT CLUTCH RESERVOIR TUBE


3. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE


F050807E01
  1. Using SST, disconnect the flexible hose tube.

    SST
    09023-00101  



4. REMOVE FRONT DOOR SCUFF PLATE LH


5. REMOVE COWL SIDE TRIM BOARD LH


6. REMOVE LOWER NO. 1 INSTRUMNT PANEL FINISH PANEL


    B085780E01
  1. Remove the 2 bolts <B>.

  1. Disengage the 3 clips and remove the lower No. 1 instrument panel finish panel.

  1. Disconnect the connectors.



7. SEPARATE DRIVER SIDE JUNCTION BLOCK


8. REMOVE CLUTCH PEDAL WITH CLUTCH MASTER CYLINDER
  1. Disconnect the clutch start switch connector.



    F050808
  1. Remove the 2 nuts and bolt, then remove the clutch pedal with clutch master cylinder.



9. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
  1. Disconnect the clutch reservoir tube.



    F050809E01
  1. Using SST, disconnect the 2 way tube from the clutch master cylinder.

    SST
    09023-00101  



    F050810
  1. Remove the nut and clutch start switch from the clutch pedal support.



    F050811
  1. Remove the 2 bolts, then remove the clutch master cylinder.