CLUTCH UNIT (for R155) > INSTALLATION |
| 1. INSTALL INPUT SHAFT BEARING |
![]() |
Using SST and a hammer, install the input shaft bearing.
Install 4 new bolts.
![]() |
Mark each bolt with paint as shown in the illustration.
Retighten each bolt by 90°.
Check that the mark on each bolt is at a 90° angle from its original position.
| 2. INSPECT INPUT SHAFT BEARING |
![]() |
Turn the bearing by hand while applying force in the rotation direction.
If the bearing is stuck or difficult to turn, replace the input shaft bearing.
| 3. INSTALL CLUTCH DISC ASSEMBLY |
![]() |
Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
| 4. INSTALL CLUTCH COVER ASSEMBLY |
![]() |
Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.
Tighten the 6 bolts, in the order shown in the illustration, starting with the bolt located near the knock pin on the top.
| 5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY |
![]() |
Using a dial indicator with roller instrument, check the diaphragm spring tip alignment.
| 6. INSTALL RELEASE FORK SUPPORT |
Install the release fork support onto the transaxle assembly.
| 7. INSTALL RELEASE BEARING HUB CLIP |
| 8. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY |
![]() |
Apply release hub grease to the release fork and release bearing assembly contact surfaces, release fork and push rod contact surface and release fork pivot point.
Install the release fork onto the release bearing assembly.
| 9. INSTALL CLUTCH RELEASE BEARING ASSEMBLY |
Apply clutch spline grease to the input shaft spline.
Install the bearing onto the release fork, and then install them onto the transaxle assembly.
| 10. INSTALL CLUTCH RELEASE FORK BOOT |
| 11. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY |