CLUTCH UNIT (for RA60F) > INSTALLATION |
| 1. INSTALL CLUTCH DISC ASSEMBLY |
![]() |
Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
| 2. INSTALL CLUTCH COVER ASSEMBLY |
![]() |
Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts, in the order starting with the bolt located near the knock pin on the top.
| 3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY |
![]() |
Using a dial indicator with roller instrument, check the diaphragm spring tip alignment.
| 4. INSTALL RELEASE FORK SUPPORT |
Install the release fork support onto the transaxle assembly.
| 5. INSTALL RELEASE BEARING HUB CLIP |
| 6. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY |
![]() |
Apply release hub grease to the release fork and release the bearing assembly contact surfaces, release fork and push rod contact surface and release fork pivot point.
Install the release fork onto the release bearing assembly.
| 7. INSTALL CLUTCH RELEASE BEARING ASSEMBLY |
Apply clutch spline grease to the input shaft spline.
Install the bearing onto the release fork, and then install them onto the transaxle assembly.
| 8. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY |