Home › TRANSMISSION ยท CLUTCH › CLUTCH START SWITCH

CLUTCH START SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH START SWITCH ASSEMBLY
  1. Install the clutch start switch assembly with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

  1. Connect the clutch start switch assembly connector.



2. INSPECT CLUTCH START SWITCH ASSEMBLY


F050784E01
  1. Check that the engine does not start when the clutch pedal is released.

  1. Check that the engine starts when the clutch pedal is fully depressed.
    If necessary, replace the clutch start switch assembly.