MANUAL TRANSMISSION UNIT > INSPECTION |
| 1. INSPECT NO. 3 SYNCHRONIZER RING OUTER |
![]() |
Apply gear oil to the cone part of gear spline piece No. 5, and check that it does not turn in both directions while pushing the synchronizer ring outer No. 3 to the gear spline piece No. 5.
If it turns, replace the synchronizer ring.
![]() |
Measure the clearance between the synchronizer ring outer No. 3 and gear spline piece No. 5 while pushing the synchronizer ring outer No. 3 to the cone part of the gear spline piece No. 5.
| 2. INSPECT NO. 3 TRANSMISSION HUB SLEEVE |
![]() |
Check that the counter shaft 5th gear and transmission hub sleeve No. 3 slide smoothly each other.
Check the tip of the spline gear of the transmission hub sleeve No. 3 for wear.
If there are any detects, replace the transmission hub sleeve No. 3.
![]() |
Using vernier calipers, measure the transmission hub sleeve No. 3 groove and the thickness of the claw part of the shift fork No. 3 to calculate the clearance.
| 3. INSPECT COUNTERSHAFT 5TH GEAR |
![]() |
Using a cylinder gauge, measure the inner diameter of the counter 5th gear.
| 4. INSPECT REVERSE IDLER GEAR SUB-ASSY |
![]() |
Using a caliper gauge, measure the inner diameter of the reverse idler gear.
Using a micrometer, measure the outer diameter of the sliding part of the reverse idler gear on the reverse idler gear shaft.
Subtract the reverse idler gear shaft inside diameter measurement from the reverse idler gear diameter clearance.
![]() |
Using a feeler gauge, measure the thrust clearance of the shoe part between the reverse idler gear and the reverse shift arm.