Home › TRANSMISSION ยท R155 MANUAL TRANSMISSION › MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL

MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL


G038871E01
  1. Using SST and a hammer, tap in the new oil seal to the extension housing.

    SST
    09223-00010  

    Drive in depth:
    -0.5 to 0.5 mm (-0.020 to 0.020 in.)

    NOTICE:
    Be careful not to damage the oil seal rip

  1. Coat the lip of a new oil seal with MP grease.



2. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for Access Cab)


D033911E01
  1. Remove SST from the extension housing.

  1. Install the propeller shaft into the extension housing.



    C060588E01
  1. Align the matchmarks on the propeller shaft flange and differential flange.

  1. Install the propeller shaft with the 4 bolts, 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



    D033899E01
  1. Provisionally install the center support bearing with the 2 mounting bolts.

    HINT:
    Make sure the bearing is installed with the drain hole facing downwards.



    F052184E02
  1. Adjust the center support bearing.

    HINT:
    1. With the vehicle unladen, adjust the center support bearing to keep the intervals, as shown.
    2. In the same condition, check the center line in the axial direction. Adjust the bearing if necessary.
    3. The center bearing center line and center bearing housing center line must be adjusted to within -1.0 to 1.0 mm (-0.039 to 0.039 in.) of each other in the vehicle's longitudinal direction when the vehicle is unladen.

  1. Torque the 2 bolts.

    Torque:
    36 N*m{ 369 kgf*cm , 27 ft.*lbf }



3. INSTALL PROPELLER SHAFT ASSEMBLY (for Regular Cab)


D033911E01
  1. Remove SST from the extension housing.

  1. Install the propeller shaft assembly into the extension housing.



    C060588E01
  1. Align the matchmarks on the propeller shaft flange and differential flange.

  1. Install the propeller shaft assembly with the 4 bolts, 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



4. CHECK FOR MANUAL TRANSMISSION OIL LEAKAGE