Home › TRANSMISSION ยท R155F MANUAL TRANSMISSION › COUNTER GEAR AND REVERSE IDLER GEAR

COUNTER GEAR AND REVERSE IDLER GEAR > REASSEMBLY

for Preparation Click here



1. INSTALL COUNTER GEAR FRONT BEARING OR ROLLER


D026124E02
  1. Using SST and a press, install the counter gear front bearing onto the counter gear.

    SST
    09515-10010  
    Install it so that the snap ring groove of the bearing faces to the front side.



2. INSTALL NO. 2 COUNTER GEAR FRONT BEARING SNAP RING


D026119
  1. Select the correct counter gear front bearing No. 2 snap ring so that the clearance between the counter gear and No. 2 counter gear front bearing snap ring No. 2 is within the specified values. Using a brass bar and a hammer, install it onto the counter gear.

    Standard clearance:
    0.1 mm (0.0039 in.) or less

    Mark
    Thickness mm (in.)
    A
    2.05 to 2.10 (0.0807 to 0.0827)
    B
    2.10 to 2.15 (0.0827 to 0.0846)
    C
    2.15 to 2.20 (0.0846 to 0.0866)
    D
    2.20 to 2.25 (0.0866 to 0.0886)
    E
    2.25 to 2.30 (0.0886 to 0.0906)
    F
    2.30 to 2.35 (0.0906 to 0.0925)