INPUT SHAFT > INSPECTION |
| 1. INSPECT INPUT SHAFT |
![]() |
Using a dial indicator and 2 V-blocks, measure the shaft runout.
![]() |
Using a micrometer, measure the outer diameter of the input shaft journal surface.
| Part | Outer diameter mm (in.) |
| A | 34.002 to 34.015 (1.3387 to 1.3392) |
| B | 44.985 to 45.000 (1.7711 to 1.7717) |
| C | 44.985 to 45.000 (1.7711 to 1.7717) |
| D | 41.985 to 42.000 (1.6530 to 1.6535) |
| E | 32.967 to 32.980 (1.2979 to 1.2984) |
| Part | Outer diameter mm (in.) |
| A | 34.002 (1.3387) |
| B | 44.985 (1.7711) |
| C | 44.985 (1.7711) |
| D | 41.985 (1.6530) |
| E | 32.967 (1.2979) |
| 2. INSPECT 6TH GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter of the 6th gear.
| 3. INSPECT 3RD GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter of the 3rd gear.
| 4. INSPECT 4TH GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter of the 4th gear.
| 5. INSPECT NO. 2 TRANSMISSION HUB SLEEVE |
![]() |
Check the sliding condition between the transmission hub No. 2 and transmission hub sleeve No. 2.
Check that the spline gear teeth of the transmission hub sleeve No. 2 are not worn.
![]() |
Using vernier calipers, measure the width of the transmission hub sleeve No. 2 groove (A) and the thickness of the claw part on the gear shift forks No. 2 or No. 3 (B), and calculate the clearance.
| 6. INSPECT NO. 3 SYNCHRONIZER RING (FOR 6TH GEAR) |
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring and the 6th gear.
![]() |
Coat the 6th gear cone with gear oil. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while pushing it to the 6th gear cone. Check that the ring locks.
| 7. INSPECT NO. 2 SYNCHRONIZER RING SET |
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring and the 3rd gear.
![]() |
Coat the 3rd gear cone with gear oil. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while pushing it to the 3rd gear cone. Check that the ring locks.
| 8. INSPECT NO. 3 SYNCHRONIZER RING (FOR 4TH GEAR) |
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring and 4th gear.
![]() |
Coat the 4th gear cone with gear oil. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while pushing it to the 4th gear cone. Check that the ring locks.
| 9. INSPECT 3RD GEAR THRUST WASHER |
![]() |
Using a micrometer, measure the thrust washer thickness.