Home › TRANSMISSION ยท RA60 MANUAL TRANSMISSION › MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL

MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL


F051836E01
  1. Using SST and hammer, tap a new oil seal into the extension housing in accordance with the dimension specified in the illustration.

    SST
    09950-60020   (09951-00640)
    09950-70010   (09951-07100)

    Dimension A:
    -0.5 to 0.5 mm (-0.197 to 0.197 in.)

  1. Apply gear oil to the lip of the oil seal.



2. INSTALL EXTENSION HOUSING DUST DEFLECTOR
  1. Using a plastic hammer, install the extension housing dust deflector.



3. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY


D033911E01
  1. Remove SST from the extension housing.

  1. Install the propeller shaft into the extension housing.



    C060588E01
  1. Align the matchmarks on the propeller shaft flange and differential flange.

  1. Install the propeller shaft with the 4 bolts, 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



    D033899E01
  1. Provisionally install the center support bearing with the 2 mounting bolts.

    HINT:
    Make sure the bearing is installed with the drain hole facing downwards.



    F052184E02
  1. Adjust the center support bearing.

    HINT:
    1. With the vehicle unladen, adjust the center support bearing to keep the intervals, as shown.
    2. In the same condition, check the center line in the axial direction. Adjust the bearing if necessary.
    3. The center bearing center line and center bearing housing center line must be adjusted to within -1.0 to 1.0 mm (-0.039 to 0.039 in.) of each other in the vehicle's longitudinal direction when the vehicle is unladen.

  1. Torque the 2 bolts.

    Torque:
    36 N*m{ 369 kgf*cm , 27 ft.*lbf }



4. INSPECT MANUAL TRANSMISSION OIL